Powerhouse PH4000Ri/E - Understanding the Digital Display

PH4000Ri/E Owner’s Manual21
6.8. Digital display
This generator is equipped with an LCD digital display that provides continuously-updated status information for the
following parameters:
• (U) Voltage—Current voltage supplied
• (I) Amperage for the generator output
• (P) Wattage (power) output for the generator
• (T) Run time—Total generator run time since rst start (in hours)
• (FUEL) Fuel level (bar reading)
• The digital display will not illuminate unless the generator is started.
• It is normal for the run time indicator to have 1-2 hours on the meter from the factory for testing and
quality assurance inspections.
The digital display will illuminate within a few seconds of the generator starting, and will initially display data from the last
run of the generator. Within a few seconds of illumination, the display will begin to show new data, and at that point the
generator is ready to supply power.
NOTE
!
IIIIIFUEL
U: 000.0 V
P: 0000 W
T: 000.0 H
I: 00.0 A
Data elds
Fault code button
Low Oil indicator (red)
P: 0261
Example fault code