11
▲ 7. If your gate has open rollers, be sure roller guards have been
purchased and installed.
INCORRECT
CORRECT
12
▲ 8. Your gate system is required to have a primary and a secondary
entrapment safety system installed and maintained.
▲ 9. If your gate closes automatically, loop detectors should be installed to
detect the presence of a vehicle.
▲ 10. DO NOT increase force adjustment to compensate for a damaged gate.
The gate should always be maintained to operate manually as easily as
possible to provide maximum protection.
▲ 11. Check all safety systems at least once per month for the correct force,
speed and sensitivity. Gate must reverse when hitting a rigid object, or when
a non-contact sensor is activated. If these functions are observed to
operate improperly, discontinue use and have it serviced immediately!
▲ 12. You are responsible for ensuring that warning signs are installed and
maintained on both sides of your gate.
▲ 13. To ensure safe operation of this equipment, you must read this safety
manual and keep it for reference.
MANUAL DISCONNECT OPERATION
▲ Your operator is equipped with a pad lockable emergency disconnect for
manual operation. Be sure you have a key and understand how to operate
this equipment. To disengage operator, move red disconnect lever to the left
and latch it in place.
▲ WARNING: NEVER OPERATE THE MANUAL RELEASE WHEN THE
GATE IS MOVING.
To Re-Engage Drive:
Lift Lever To Unlatch,
Then Move Lever To
The Right.
To Disconnect Drive:
Move Lever To The Left Until
It Latches In Retaining
Bracket.
Padlock
Option Hole
Retaining
Bracket
Disconnect
Lever
To Next Page
Loading...
Need help?
General
