11
www.powershield.com.au
Step 5: Turn on the UPS
Press the ON/Mute button on the front panel for two seconds to power on the UPS.
Note: The battery will fully charge during the first few hours of normal operation. Do not
expect full battery run capability during this initial charge period.
Step 6: Software Installation
For optimal computer system protection, install the UPS monitoring software to fully configure
UPS shutdown.
Follow the steps below to download and install NetGuard monitoring software:
1. Go to the website www.powershield.com.au
2. Click Downloads software icon and choose your required OS to download the NetGuard
software in the https://powershield.com.au/downloads downloads page.
3. Follow the on-screen instructions to install the NetGuard software.
4. When the computer re-starts, the NetGuard monitoring software will appear as an orange
plug icon located in the system tray, near the clock.
To Next Page
Loading...
