For safety reasons, it is essential to comply with all warnings and operating instructions listed
in this manual. Do not operate the UPS unit before carefully reading through all safety
information and operating instructions. It is recommended that you save and or backup this
manual for future reference.
1-1. Transportation
Transport the UPS system using only the original packaging to protect against shock
and impact.
Handling Safety
Do not lift heavy loads without assistance.
This equipment is intended for installation in a controlled temperature indoor area free
from conductive contaminants.
1-2. Preparation
The UPS system must be absolutely dry before installation. As condensation may
occur if the UPS system is moved directly from cold to warm environments, allow at
least two hours for the UPS system to acclimate to the environment.
Do not install the UPS system near water or in moist environments.
Do not install the UPS system where it would be exposed to direct sunlight or near
heaters.
Do not block ventilation holes in the UPS housing.
1-3. Installation
Do not connect appliances or devices that may overload the UPS system (e.g. laser
printers) to the UPS output sockets.
To ensure against physical hazards, place cables safely such that persons cannot
accidentally trip over or step on them.
Do not connect domestic appliances such as hair dryers to UPS output sockets.
The UPS can be operated by any individual without previous experience.
Always connect the UPS system to an earthed shockproof outlet that is easily
accessible and close to the UPS system.
To Next Page
