powersoft K2 DSP+AESOP User Manual

▶
18
K Series User Guide
Settings
Analog => Out Analog => DSP => Out
1
AES3 => Out
1
AES3 => DSP => Out
1
KAESOP => Out
2
KAESOP =>DSP => Out
1, 2
Output attenuation Input gain/sens Inuput select Max output voltage Max mains current Clip limiter CH1 Clip limiter CH2 Gate CH1 Gate CH2 Mute at Power on Idle Mode
Amplifier Settings DSP Settings
1
Network Settings
2
see “DSP Settings” diagram Device mode Addressing mode Set address Show net config Audio
Repeat (default) Forward to AES3-A Forward to AES3-B Forward to both
IP address subnet mask Default gateway
Source selection Source mode Gain trim If no link
AES3-XLR rear panel AES3-A AES3-B Parallel from L Parallel from R Stereo Mute Analog
Display
Local presets
Setup
Output meters Temperature Mains meters Amplifier name
Display Amp data Edit Amplifier name
Lock presets Locked bank size Recall local preset Save local preset Change lock code Erase all presets Hardware Info Hardware Monitor LCD contrast Set Keylock code Service
1
Available only with optional DSP board
2
Available only with optional KAESOP board
Menu
FIGURE 26: K Series main menu map

powersoft K2 DSP+AESOP Specifications

General

Brand	powersoft
Model	K2 DSP+AESOP
Category	Amplifier
Language	English