6
b. Recover when load is reduced: resume normal charging( 30A) when the heat sink
temperature is <70°C.
c. Stop charging when the heat sink temperature is ≥90°C; resume charging when the heat
sink temperature is <60°C.
5. External temperature compensaon funcon
(only for AGM/STD baery)
a.1.The system will automacally adjust the float voltage according to the ambient temperature.
The external temperature probe is preferred. If the external temperature probe is not connected
(or the external temperature is <-40°C), use (temperature ≥ 20°C± 5°C) by default. 2. The voltage
may vary when the input energy is insufficient to stabilize the energy required for the float
charging.
1. 12V baery charging temperature ≤0°C- -40°C 14.1 ±0.3 VDC
(test external analog resistance430K (-20°C))
2. 12V baery charging temperature: 0°C-20°C±5°C 13.8 ±0.3 VDC
(test external analog resistance 100K (10°C)
3. 12V baery charging temperature ≥20°C±5°C 13.5 ±0.3 VDC
(test external analog resistance 39K (30°C)
4. 24V baery floang charge temperature ≤0°C- -40°C 28.2 ± 0.3 VDC
(test external analog resistance 430K (-20°C)
5. 24V baery floang charge temperature 0°C-20°C±5°C 27.6 ±0.3 VDC
(test external analog resistance 100K (10°C)
6. 24V baery floang charge temperature ≥20°C±5°C 27 ±0.3 VDC
(test external analog resistance 39K (30°C)
6. WIFI networking funcon
a. The product may integrate WIFI module or not.
b. If the product integrates a WIFI module, you can install the mobile APP, control the load
switch through the APP and vie
w the MPPT charger data in real me, such as baery
voltage, charging current, etc.
7. The LCD backlight is turned off if there is no buon operaon in 1 minute; any buon
operaon will automacally acvate the LCD backlight.
8. a. USB baery input undervoltage/overvoltage protecon (10.5V/30.5V), baery input
undervoltage/overvoltage recovery (11V/30V);
c. USB output 2*5V/3A.