powertronics PQR D52 - Setting Baud Rate; Selecting Communication Baud Rate; Baud Rate Change Implications

PQR Series Model D52
Page 36
www.Powertronics.com
V2.1
C6 - (Option 2) Set the Baud Rate:
This Command allows the operator to change the communications Baud rate setting inside the
PQR D52.
Select Option 2: 2
The PQR D52 will respond by transmitting the following message:
Typing the number indicated next to the desired rate will change the rate of the PQR D50/52
immediately to the new rate.
Note:
Changing the baud rate breaks down the connection between the PQR D52 and the
communications devices must be changed to match the new rate of the PQR D52.
When the rate is changed, the new setting is saved in FLASH RAM, and is used as the power up
default until the next time the setting is changed.