PQR
Series Model D52
Page 37
www.Powertronics.com
V2.1
C6 - (Option 3) Set the Data Logger:
This Command allows the operator to change the interval
between data logger readings inside the PQR D50/52.
Select Option 3: 3
The PQR D50/52 will respond by transmitting the following message
Typing the number indicated next to the desired rate will change the
rate of the PQR D50/52 immediately to the new rate.
Note:
When the rate is changed, the new setting is saved in Non-
Volatile Ram, and used as the power up default until the next time the
setting is changed.
Enter the number of seconds between Data log samples
1)1 Sec 2) 5 Sec 3) 10 Sec
4) 30 Sec 5) 1 Min 4) 4 Min
Any other choice sets the rate to 1 Minute.
New Rate:
To Next Page
Loading...