PRECITEC CHRocodile C - SSU Command; STA Command

60
2.12 SSU Command
Short description:
The command SSU saves Setup
Saves current setup to non-volatile memory. The Setup will be restored upon next power up.
Command syntax:
$SSU
Command
Description
$SSU
Response: $SSU [CR]ready[CR/LF].
Saves current setup
2.13 STA Command
Short description:
The command STA starts serial data output
This mode can be stored in the nonvolatile memory. If stored, the CHRocodile C will begin
immediately to output data telegrams on the next power-up.
Command syntax:
$STA
Command
Description
$STA
Response: $STA [CR]ready[CR/LF].
Starts serial data output