10
use the original devices and replacement parts and observe the
instructions for EMC-
compliant installation in the handbooks that
come with them.
If the opti
cal sensor is operated inside a facility with other devices, the
entire facility must comply with the provisions in the EC-
the demands of the general operating permit.
1.4 Duty of Operator and Personnel
The operator of the device is obligated only to allow persons to work on the device who:
are familiar with the basic regulations concerning workplace safety and accident prevention and
who have been instructed in the operation of the device
have read and understood the safety chapter of this op
eration manual and have confirmed this with
their signature.
The personnel must be trained in compliance with the regulations and safety instructions and must
have been informed of possible hazards.
1.5 Safety Measurements in Normal Operation
When it is assumed that the device can no longer be operated safety, the device or the plant must be
taken out of operation. The device must be secured against unintended use. Unauthorized
interventions will void your rights to assert warranty claims.
Any attempt to copy or analyze the software will lead without fail to the voiding of all rights to assert
warranty claims.
1.5.1 Protection from Electronic Shock
Please make sure that the live components are uncovered after
opening the housing or removing components. Touc
components presents a potentially lethal hazard.
When service-
and repair work is performed on opened devices and
modules, the main power supply must be reliably shut off (mains cable
unplugged).
1.5.2 Protection from Optic Radiation / Eye Safety
When performing service and maintenance work, make sure that you
To Next Page