24
but the edge can also be inverted by software command) on the rising edge, that means when the
external pulldown transistor releases the input or when the pushpull drives to 5V.
Wait for trigger – signal characteristics to Analog Out
The sensor stops after the current data telegram is transmitted and
goes into a standby mode.
The last transmitted analog value persists until the next exposure
(also see TRG command).
2.6.7 Status LED
LED Status CHRocodile CLS Status
No Signal
RED LED
Flashing GREEN LED
BLUE LED
Flashing BLUE / GREEN LED
GREEN LED
Power OFF
Power ON, Firmware badly configured
Power ON, Firmware is configuring
Power ON, Firmware is configured / Continuous Measurement
Power ON, Triggering session
Power ON, Waiting for Trigger
Table 2.5: Status LED definition
To Next Page