9
W
ARNING
Do not touch –
indicates that touching the contact/optics surface can
cause damage/destruction of the component.
I
MPORTANT
Information which the user must pay attention to/ be aware of in order to
avoid disruptions in the course of processing/ in product use.
T
IP
Provides information that the user needs in order to achieve the
intended result of an action most directly and without difficulty.
P
REREQUISITE
Describes all components as well as all conditions that must be present/
be fulfilled in order to the action to be successfully completed.
A
DDITIONAL
I
NFORMATION
Informs the user whenever there is add
itional information about a
context being described.
1.3 Proper Use
The optical sensor is intended as a stand-
alone device or as part of a measurement apparatus for
measuring distance, thickness and surfaces for quality and dimensional control.
Only use
the optical sensor in a dry environment. The device may only be operated within the
specifications given in the technical data.
Any use deviating from the intended and proper use is considered
improper. The user assumes liability for the consequence
cases.
Electromagnetic
Compatibility (EMC)
Both as an individual device and in combination with the devices
designated in this documentation, the optical sensor fulfils the
requirements of the standards DIN EN 61326-1:2013-07 and
61010-1:2011-07, and therefore corresponds to the EU-
Directive
2014/35/EU and 2014/30/EU. This declaration is valid for all units with
the CE label on it, and it loses its validity if a modification is done on
the product.
When customer-supplied devices or cab
les are used this can mean
that these Norms may not be fulfilled. For this reason, you should only
To Next Page
Loading...