38 Assembling and Maintaining AMT 800-Series Adaptive Motion Trainers
3. Reinsert the two set screws. Leave the screws partially
tightened until you have adjusted both handlebars.
4. Repeat steps 1 through 3 to position the other handlebar.
5. Adjust the positions of both handlebars outward as much
as possible. Both handlebars should be at equal angles to
the body of the AMT and angled slightly outward, as
shown in the following figure.
Figure 22: View of handlebar placement
6. Rotate one of the plastic boots so that it aligns with the
surface below it, then press the boot downward to secure
it in place. Repeat this step to position the other plastic
boot.
To Next Page
Loading...
Need help?
General
