62 Assembling and Maintaining AMT 800-Series Adaptive Motion Trainers
Weekly Maintenance
Perform the following maintenance tasks every week:
1. Disconnect the external power supply.
2. Clean the floor under the equipment using a vacuum
cleaner or a damp mop.
3. When the floor is completely dry, reconnect the power (if
necessary).
4. Test all console functions, including heart rate monitoring
features.
5. Verify that the unit sits squarely on the floor. All of its feet
should be touching the floor and the unit should not rock
or wobble when in use. If not, re-level it as described in
Leveling the AMT.
Monthly Maintenance
Perform the following maintenance tasks every month:
1. Wipe the exterior of the console with a damp sponge or
soft cloth, and dry with a clean towel. Keep water away
from electronic components to prevent electrical shock or
damage.
2. Clean the touchscreen using a soft, lint-free cloth
dampened with a 91% isopropyl alcohol solution (either
as sold or diluted with an equal amount of water).
3. Wipe down the pedal belts using a clean, dry cloth.
Important: Do not use any cleaning solution or solvent on
the pedal belts. Over time, cleaners can cause the outer
layers of the belts to deteriorate.
4. Remove the access covers. Vacuum out any debris, being
careful not to bring the vacuum cleaner nozzle too close
to any circuit board (unless your vacuum cleaner is
protected against static buildup).
5. Check the belt tension of the primary, brake, and drive
belts (refer to the service manual for detailed
instructions).
6. Check all fasteners for proper tightness and torque.
7. Replace all covers.
8. Verify that the unit sits squarely on the floor. All of its feet
should be touching the floor and the unit should not rock
or wobble when in use. If not, re-level it as described in
Leveling the AMT.
To Next Page
Loading...
Need help?
General
