© Precor Incorporated, Unauthorized Reproduction and Distribution Prohibited by Law
Figure 109: Stairarm and Stairarm Pedal
Stairarm Pedal Replacement Procedure
1 Pivot the stairarm up into a vertical position. Note: The following
procedure will be much more efficient if a assistant holds the
stairarm up.
2 Remove the four screws, washers and washer plate that secure the
stairarm pedal to the stairarm, remove the stairarm pedal.
3 Fasten the replacement stairarm pedal to the stairarm using the four
screws, washers and washer plate removed in step 2.
4 Torque the screws to 15 inch pounds, starting from the single screw
at the end of the stairarm, than screw mounted in the middle,
finally the two rear pedal screws.
To Next Page
Loading...
