Precor AMT 885 - Figure 138: Flat Belt Terminal Covers; Figure 139: Flat Belt Removal - Terminal

© Precor Incorporated, Unauthorized Reproduction and Distribution Prohibited by Law
Page 213
Figure 138: Flat Belt Terminal Covers
Flat Belt Removal - Rear Terminal
Note: Any time the flat belt terminal screws are removed from the flat belt
clamp or cams, the screws must be discarded and replaced with new
screws.
10 Remove and discard the two 1/4-20X1 screws and shims that secure the
flat belt to the clamp.
Figure 139: Flat Belt Removal - Terminal