page 28
COMMERCIAL PRODUCTS DIVISION
The SmartRate
®
and Heart Rate system is standard equipment. The heart rate
receiver is factory-installed in the display console. To actively view the SmartRate
®
and heart rate displays, a user must wear a chest
strap, face the display console,
enter his or her age (during the Setup prompts), and begin a program. The user’s
heart rate is transmitted from the chest strap to the receiver inside the console
and appears on the display. A blinking segment approximates the user’s heart rate
and shows which zone the heart rate is in: weight loss or cardiovascular.
Important: During a program, a user’s heart rate must be above 40 beats per
minute before the segment begins to blink. Note that pressing
QUICKSTART
at
the PRECOR banner causes the SmartRate
®
display feature to be inactive.
SETUP MODE AND PROMPTS
The PRECOR banner is the “starting point” when a user begins a workout. If the
banner does not scroll across the display, press the RESET key. If the display
appears blank, make sure that the treadmill is turned ON. Press the ON/OFF [I/O]
switch located at the front, near the power receptacle, to ON.
PRECOR banner: From the PRECOR banner, a user presses the SELECT key
to access the Setup mode which lets a user determine the program, workout
time, weight, and age parameters as described below.
Note: Key presses to the INCLINE ▼▲ or SPEED ▼▲ keys are ignored when the
banner is being displayed. Refer to page 31 for more information about the keypad.
MANL: The program prompt, MANL, indicates that the C932i is ready to accept
program entries. To help a user determine which program they want to use, the
program names and profiles appear on the display console label. The ▼ and ▲
keys let a user scroll through the available programs. The display presents the
abbreviated name of the program. To choose the selection being displayed and
continue in Setup mode, press SELECT. (Refer to
The Setup Mode and the
QUICKSTART Feature
on page 29.)
Note: Depending on the program that is selected, a user may be prompted for
other information. Refer to
C932i Programs
on page 42.
XX MIN: Acceptable entries at the workout time prompt range between NOLIM (zero)
and 99 minutes. Use the ▼ and ▲ keys to change the selection. If the club allows it
and a user wants to work out indefinitely, they can choose NOLIM. A cool-down
period will not be appended to the program. Note that the Weight Loss program has a
preset time limit so a user will not be prompted for a workout time when they choose
WTLS. A user cannot workout indefinitely in the Weight Loss program.
To continue in Setup mode, press SELECT.
Important: The club has the option to set limits on program duration and cool
down and pause time. Refer to Club Information on page 21.
To Next Page
Loading...
Need help?
Power
Performance
Weight and Dimensions
