Attaching the Knee Roller Pads
The knee roller pads on this equipment, and the roller bar that supports them,
are anchored to a bracket just above and ahead of the seat.
To install the knee roller pads:
1. Slide the roller bar through its anchor bracket.
2. Insert one M8 x 6 set screw into each screw hole in the bracket. Tighten
both screws completely.
Figure 17: Set screw attachment
3. Slide a knee roller pad and one end cap onto the roller bar and secure it
with one M6 x 30 flat head cap screw.
Note: There is a small pin on each end of the roller bar and a small hole
next to the center hole on each end cap. The pin must extend into the hole
for the end cap to be properly positioned.
Figure 18: Knee roller attachment
4. Repeat the previous step to attach the remaining knee pad.
To Next Page
Loading...
