5.17i Elliptical Fitness Crosstrainer
Page 35
Diagram 7.2 - Upper and Lower Front Cover Sections
7. If all of the cover sections have been removed, first replace lower and upper front cover
sections, then the top cover section and then the left and right cover sections as described
below.
8. Fasten the lower front cover section to the frame with two phillips head screws. Fasten the
upper front cover section to the frame with two phillips head screws
9. Set the top cover section in it’s mounting position, replace and tighten the two phillips
screws that fasten the top cover section to the frame upright. See Diagram 7.1. Replace and
torque the three screws that fasten the top cover section to the rear cover support to 30 inch
pounds. Replace and torque the two screws that fasten the top cover section to the front
cover section to 30 inch pounds.
10. Set the left cover section in it’s mounting position, replace and torque the four screws that
fasten the left cover section to the front cover section, top cover section and rear cover
support. to 30 inch pounds.
11. Set the right cover section in it’s mounting position, replace and torque the four screws that
fasten the right cover section to the front cover section, top cover section and rear cover
support to 30 inch pounds.
Upper
Front
Cover
Lower
Front
Cover
To Next Page
Loading...
