Precor EFX 5.17i - Procedure 7.23 - Replacing a Lift Motor

5.17i Ellipitical Fitness Crosstrainer
Page 76
Procedure 7.23 - Replacing a Lift Motor
1. Set the on/off switch in the “on” position. Lower the ramp to incline level 1 and set the on/off
switch in the “off” position. Remove the front cover.
2. Disconnect the lift connector from the intermediate lift cable (See Diagram 7.25).
3. Remove the two screws that fasten the keeper to the cover and remove the keeper.
4. Remove the two retaining clips from the lift pins. While supporting the ramp, remove the two
lift pins and carefully lower the ramp assembly until it is resting on the rear portion of the
front cover.
Diagram 7.25 - Lift Motor Mounting
Lift Pin
Retaining Clips
Lift Pin
L
Lift Nut
Keeper
Lift Connector