5.17i Ellipitical Fitness Crosstrainer
Page 6
3. Watch the display as the LED test progresses. The test is programmed to display the
following LED illumination sequence:
a. The test name “DISPLAY TEST” will be scrolled.
b. All of the L.E.D.s on the display will be illuminated.
3. Press the RESET key to proceed to the keyboard test.
4. The test name “KEYBOARD TEST” will be scrolled.
5. A graphical representation of all the keys on the keyboard will be displayed. When a key is
pressed the representation of the key will become a single dot. Check all of the keys on the
keyboard in this manner.
6. Press and hold the RESET key for a minimum of 2 seconds to proceed to the heart rate test.
7. The test name “HEART RATE TEST” will be scrolled.
8. If the optional heart rate receiver is not installed, the message “NO HEART RATE
RECEIVER will be scrolled. Skip to step 11.
9. A chest strap heart rate transmitter or a heart rate test transmitter must be used in
conjunction with this test.
10. When a heart rate signal is received, the Polar heart rate will be displayed as “P XXX” and
the SCAN L.E.D. will flash in time with the heart rate. Press the SELECT key, the unfiltered
heart rate will be displayed as “U XXX”. Press the SELECT key, the filtered hear rate will
be displayed as “F XXX”.
11. Press the RESET key to proceed to the lift test.
12. The test name “LIFT A/D TEST” will be scrolled.
13. The lift calibration number will be displayed on the right. The lift calibration number indicates
the physical position of the incline and is used to calibrate the lift motor. Press the SELECT
key, RAMP will scroll followed by the ramp position. Press the SELECT key, SEC TO CHG
will scroll followed by the transition time. Press the SELECT key, GLITCHES will scroll
followed by the glitch count.
14. Press the RESET key to proceed to the brake test.
15. The test name “BRAKE” will be scrolled
To Next Page
Loading...
