5.17i Elliptical Fitness Crosstrainer
Page 69
9. Hand start both lower mounting bolts remove in step 6. Torque both bolts to 35 foot pounds.
10. Raise the ramp and position it so that the ramp mounting holes align with the holes in the
plastic lift nut. If it is necessary to rotate the lift nut to align it with the ramp, do not rotate it
any more than is required for alignment. Slide both lift pins through the ramp mounting holes
and into the plastic lift nut. Fasten both lift pins with the retaining cli[ps removed in step 4.
11. Rotate both stairarms forward and place them on the ramp tracks.
12. Replace the left and right rear covers per Procedure 7.1. Replace the front cover.
To Next Page
Loading...
