13. Press the ENTER key to save the currently displayed selection and exit the set cool down
time display.
14. The display name “SET CROSSRAMP AUTO-LEVEL” will be displayed, press the OK key
to proceed to the set crossramp auto-level display or an
S, T key to proceed to a different
display.
15. Please note, on EFX’s equipped with version 4.00 upper software, the EFX must be pedaled
to allow the incline to activate.
16. The current auto-level position will be displayed. Pressing any
S, T key will increase or
decrease the auto-level position between level 0 and level 20.
17. Press the ENTER key to save the currently displayed selection and exit the set auto-level
display.
18. Press the RESET key to exit the set user parameters program
To Next Page
Loading...
Need help?
General
