Procedure 2.2 - Accessing the Diagnostics Test
Procedure
1. Plug the power cord into the wall outlet, then turn on the EFX with the on/off switch.
2. With the PRECOR EFX banner displayed, press keys RESET,6,5, sequentially.
Diagnostics Test
Odometer
Hour meter
U-Boot Software version
U-Base Software version
Lower software version
Usage Log
Error log
4. The test name DIAGNOSTICS TEST will be displayed. Press the OK key to proceed to
odometer. Use the
S, T keys to proceed to the desired display.
4. The display name “ODOMETER” will be displayed, press the OK key, the odometer value
will be displayed, as total strides accumulated.
5. Press the ENTER key to proceed to the hour meter display.
6. The display name “HOUR METER” will be displayed, press the OK key, the hour meter will
be displayed, as the total number of hours of use. Fractional parts of an hour are stored
internally, the display will be truncated to the nearest full hour.
7. Press the ENTER key to proceed to the U-Boot software version display.
8. The display name “U-BOOT SW” will be displayed, press the OK key, the U-Boot software
part number will be displayed.
9. Press the ENTER key to proceed to the U-Base software version display.
10. The display name “U-BASE SW” will be displayed, press the OK key, the U-Base software
part number will be displayed.
11. Press the ENTER key to proceed to the lower software version display.
12. The display name “LOWER SW” will be displayed, press the OK key, the lower software
part number will be displayed.
13. Press the ENTER key to proceed to the usage log.
14. The display name “USAGE LOG” will be displayed, press the OK key.
15. The program used and the time the program was used will be displayed.
To Next Page
Loading...
Need help?
General
