Procedure 7.21 - Replacing a Front Cover Section
1. Set the on/off switch in the “off” position, then unplug the power cord from the wall outlet.
2. It is only necessary to perform as much of this procedure as is required to access the cover
being replaced.
3. Grasp the upper front cover section and lift upwards to remove it. See Diagram 7.20
Diagram 7.20 - Front Covers
4. Remove the four screws that fasten the top cover section. See Diagram 7.21.
Diagram 7.21 - Top Cover with Upper Front Cover Removed
Upper Front Cover
Lower Front Cover
Upper
Mounting
Screws
Lower Mounting
Screws
To Next Page
Loading...
