Procedure 2.3 - Accessing the Set User Parameters Display
Selecting United States standard units causes information to be displayed in miles. Information is
displayed in kilometers if metric units are selected. After you select a measurement standard, the
software accumulates and records workout information in the units of the measurement standard
selected.
Procedure
1. Plug the power cord into the wall outlet, then turn on the EFX with the on/off switch.
2. With the PRECOR EFX banner displayed, press keys RESET,5,6,7,1, sequentially. On the
5.37 press the OPTIONS key.
Diagnostics Test
Select Units
Set Max Pause Time
Set Cool Down
Set Crossramp Auto-Level
3. The display name “SELECT UNITS” will be displayed, press the OK key to proceed to the
select units display or an
S, T key to proceed to a different display.
4. One of two measurement standards will be displayed, U. S. Standard or Metric.
5. If U. S. Standard is selected, weights will be in pounds and distances will be in miles. If
Metric is selected, weights will be in kilograms and distances in kilometers.
6. Pressing any
S, T key will toggle the units of measure between US Standard and Metric.
7. Press the ENTER key to save the currently displayed selection and exit the select units
display.
8. The display name “SET MAX PAUSE TIME” will be displayed, press the OK key to proceed
to the set max pause time display or an
S, T key to proceed to a different display.
9. The current pause time will be displayed. Pressing any
S, T key will increase or decrease
the maximum pause time between 0 and 10 minutes.
10. Press the ENTER key to save the currently displayed selection and exit the set max pause
time display.
11. The display name “SET COOL DOWN TIME” will be displayed, press the OK key to
proceed to the set cool down time display or an
S, T key to proceed to a different display.
12. The current cool down time will be displayed. Pressing any
S, T key will increase or
decrease the cool down time between 0 and 5 minutes.
To Next Page
Loading...
Need help?
General
