Procedure 2.1 - Accessing the Hardware Validation Program
The EFX diagnostic software cycles through the following tests:
Hardware Validation
Display Test
Keyboard Test
Heart Rate Test
Machine Test
Brake
PWRB
Crossramp Test
LIFT A/D
Auto leveling
Procedure
1. Plug the power cord into the wall outlet, then turn on the EFX with the on/off switch.
Note:
Use the RESET key and the ten key keypad to enter the access code.
2. With the PRECOR EFX banner displayed, access the diagnostic program by pressing, keys
RESET,5,1,7,6,5,7,6,1, sequentially.
Diagram 2.1 - 5.37 Display
To Next Page
Loading...
Need help?
General
