16. The keys S, T will scroll you through the list of programs that have been used.
17. Press the ENTER key to proceed to the error log display
18. The display name “ERROR LOG” will be displayed press the OK key.
19. The first error log entry will be displayed (1: ERXX @ XX STRIDES XX HRS) .
20. Pressing the
S, T keys will move you through the log entries. Entry 1 will be the most recent
error log entry, with each succeeding entry being older than the preceding entry.
21. If the error log is empty NO ERRORS will be displayed.
22. Pressing and holding the QUICK START key for 2 seconds will cause the prompt CLEAR?
to be displayed, holding the QUICK START for an additional 2 seconds will clear all existing
entries from the error log. The display will confirm that the error log has been cleared by
displaying OK. The display will revert to the first log entry and show it as a null entry (1: ---).
If the QUICK START key is not held for a minimum of 4 seconds, the error log will not be
cleared.
23. Press the RESET key to exit the diagnostics display program.
24. Note: the error log can also be entered at any time by pressing and holding the RESET key
for four seconds.
To Next Page
Loading...
