5. The lower rear cover must be removed before the upper rear cover. Plug the power cord in
the A.C. outlet and set the on/off switch in the “on” position. Lower the incline to its lowest
position.
6. Remove the two screws in the upper portion of the lower rear cover. Slide the rear cover
rearward and off of the EFX. See Diagram 7.23.
Diagram 7.22 - Lower Rear Cover, Rear View
7. Raise the incline to its highest position. Remove the two screws from the rear of the lower
portion of the rear cover. See Diagram 7.22.
Diagram 7.23 - Upper Rear Cover, Rear View
8. Lower the incline to its lowest position, set the upper rear cover in its mounting position and
fasten it with the two screws removed in step 7.
9. Raise the incline to its highest position and set the lower rear cover in its mounting position
and fasten it with the screws removed in step 6, torque the screws to 6-9 inch pounds.
10. Set the on/off switch in the “off” position, then unplug the power cord from the wall outlet.
11. Set the lower front cover in its mounting position ensuring that the tabs in the lower front
cover align with the pockets in the lower and upper rear covers. Snap the front cover into
place and fasten it with the screws removed in step 4, torque the screws to 6-9 inch pounds.
12. Set the upper front cover in its mounting position and snap it into place.
Lower Rear
Cover
Mounting Screws
Upper Rear
Cover
Mounting Screws
To Next Page
Loading...
