20. The incline percentage will be displayed on the left and the A/D (lift calibration) number will
be displayed on the right. The lift A/D number indicates the physical position of the incline
and is used to calibrate the incline. The A/D number will range from 34 (level 1) to 223
(level 20).
21. Press the OK key to proceed to the auto-level test.
22. The test name “AUTO-LEVEL” will be displayed, press the OK key to enter the Lift A/D test.
23. Please note, on EFX’s equipped with version 4.00 upper software, the EFX must be pedaled
to allow the incline to activate
24. If the incline is not at the auto-level position it will move to the auto-level position.
25. When the incline reaches the auto-level position, the display will return to the machine test,
step 13. you may then proceed to another test using the
S, T keys
26. You may press the RESET key at anytime in the hardware validation program to exit the
hardware validation program.
To Next Page
Loading...
Need help?
General
