Diagram 5.7 - Pillow block Mounting Bolts
6. Using a rubber mallet, gently tap the top of the pillow block with two loosened bolts (the right
hand pillow block in Diagram 5.7) until the two measurements in Diagram 5.6 are within 1/16
inch.
7. Torque the three loosened pillow block mounting bolts to 120 inch pounds (10 foot pounds).
Input Drive Axle to Step Up Pulley Axle Alignment
8. Mark the current position of the step up pulley on both side of the drive weldment.
9. On both sides of the drive weldment measure the distance from the input drive axle to the
step up pulley axle. See Diagram 5.8.
Diagram 5.8 - Axle to Axle Measurement
Loosen
Loosen
Loosen
Do not Loosen
Tap Here
Measurement
Step Up Pulley Axle
Input Drive Axle
Adjustment Nut
To Next Page
Loading...
