13. Tape the replacement lower data cable to the lower PCA end of the existing data cable.
Carefully pull the existing lower data cable out of the hole in the frame, near the near the left
outrigger tube, as you feed the replacement data cable into the frame. Stop when the
replacement data cable appears out of the hole in the frame near the left outrigger tube.
14. Remove the tape fastening the two data cables and discard the old data cable.
15. Reconnect the data cable to the lower PCA.
16. Connect the data cable to the mid-point connector, place the cables and mid-point
connector in the frame.
17. Reinstall the left outrigger tube per Procedure 7.22.
18. Replace the left, right, top and access panel rear cover sections per Procedure 7.1.
19. Check operation as described in Section Four.
To Next Page
Loading...
