7. Slide the stairarm pivot block onto the crankarm pin and replace the wave washer, flat
washer and retaining ring removed in step 6.
8. Slide the stairarm onto the stairarm pivot block. Ensure that the red spacer is on the top and
the clear spacer is on the bottom of the pivot block as shown in Diagram 7.11. Install and
hand tighten the stairarm pivot block mounting hardware. The mounting bolt head must be
on the top of the stairarm as shown in Diagram 7.11. Torque the stairarm pivot block
mounting bolt to 180 inch pounds (15 ft./lbs).
9. Replace the left, right, top and access panel cover sections per Procedure 7.1.
10. Check EFX operation per Section 4.
To Next Page
Loading...
