4. Remove the outrigger tube per Procedure 7.22.
5. Using a 1/2 inch wrench the moveable handlebar’s axle, unscrew and remove the moveable
handlebar. See Diagram 7.18.
Diagram 7.18 - Moveable Handlebar
6. Set the replacement moveable handlebar in its mounting position. Carefully start hand
threading the moveable handlebar to avoid cross threading and then tighten..
7. Replace the outrigger tube per Procedure 7.22.
8. Set the connecting link in its mounting at the lower end of the moveable handlebar and
fasten it with the hardware removed in step 2.
9. Depress the orange button on the rearward end of the connecting link and install on it either
the stairarm or its storage point as required.
10. Check EFX operation per Section 4.
Moveable
Handlebar
Axle
To Next Page
Loading...
