Diagram 7.30 - Removing the Yoke from the Ramp
9. Note the orientation of the incline yoke, the replacement yoke must be installed in the same
orientation. If the replacement yoke is installed upside down the incline will go too low and
damage the cover. See Diagram 7.31.
10. Taking care to not allow the incline motor’s drive screw rotate, thread the incline yoke off of
the incline motor’s drive screw. If the incline motor’s drive screw rotates, the incline motor
will need to be calibrated per Procedure 5.3.
Diagram 7.31 - Incline Yoke Orientation
11. Taking care to not allow the incline motor’s drive screw rotate, correctly orient the
replacement incline yoke and thread it onto the incline motor’s drive screw until it is in the
same position as noted in step 5. If the incline motor’s drive screw rotates, the incline motor
will need to be calibrated per Procedure 5.3.
To Next Page
Loading...
