page 41
COMMERCIAL PRODUCTS DIVISION
In Pause
mode, you This is what happens...,
resume pedaling Returns to the course and the workout statistics continue from
where you left off.
press Reset Displays the Workout Summary banner.
exceed time limit The EFX exits Pause mode, resets the displays, and turns off.
In Cool down
mode, This is what happens...,
no pedaling
or slow pedaling
is detected Enter Cool down, Pause mode. Workout time stops accruing
and PEDAL FASTER appears on the display. If you enter Pause
mode, it is of limited duration. Check with staff personnel or
refer to
Custom Settings Mode
on page 25 and
Informational
Displays Prior to Shutdown
on page 33.
you press Reset Displays the Workout Summary banner. See Reset on the
previous page.
it ends. Displays the Workout Summary banner.
At the Workout
Summary
banner, you This is what happens,...
press Reset The workout statistics are reset to zero and the EFX shuts off.
INSERTING THE LOCKING PIN
To secure the EFX
after your workout, take the following steps:
1. Locate the locking pin in its storage location under the ramp. Refer to
Diagram 27 on page 36.
2. Remove the locking pin from its stored location and insert it into the roller
arm. Position the locking pin so that you insert it from the outside edge of the
ramp toward the inside edge.
3. Firmly slide the locking pin through the holes in the roller arm. Be sure that the
locking pin is all the way through roller arm. Refer to Diagram 27 on page 36.
Gently move the roller arm to make sure that it is secure.
To Next Page
Loading...
Need help?
Power
Electronic Specifications
Weight and Dimensions
