page 28
COMMERCIAL PRODUCTS DIVISION
Because of its advanced design, the EFX544 requires little maintenance beyond
periodic cleaning which is explained in this section. Keep in mind that, as owner
of this machine, you are solely responsible for its maintenance.
CAUTION: Turn OFF and unplug the EFX544 from the power outlet before
performing any maintenance tasks, such as cleaning.
CLEANING THE EFX544
On a daily basis, use mild soap and water on a damp, soft, clean cloth to clean
the foot pedals, exposed incline rails, handrails, plastic roller wheels, and front
and rear covers. This removes any dirt or dust which might affect the smooth
operation of the EFX544.
CAUTION: Never pour water or spray liquids on the electronic console or
any part of the EFX544 Take special care when cleaning the console to
avoid scratching its surface. Allow the EFX544 to dry completely before
using.
Clean the surface of the electronic console with a damp, clean, soft cloth. Dry the
surface thoroughly with a clean towel.
Vacuum around the unit every week to prevent the accumulation of dust and dirt.
ACCESSING THE ODOMETER
To access the odometer reading, simultaneously press and release the
RAMP and RESISTANCE keys. The odometer appears in the right display
windows. A maximum of 12 numerical characters are available (or 1 trillion
strides). Press ENTER to return to the “WEIGHT” prompt.
CONVERTING STRIDES TO MILES
To convert the number of strides into miles or kilometers, use one of the following
formulas:
# of strides ÷ 2,241 = # of miles
# of strides ÷ 1392.5 = # of kilometers
The formula is based on the fact that a stride represents 1/2 revolution. Pi
multiplied by the radius (3.14 x 9") yields 28.3 inches (or 72 cm). Divide the yield
into inches per mile (or centimeters per kilometer) and you come up with the
constant used in the formula above.
Maintaining the EFX544
To Next Page
Loading...
