page 11
COMMERCIAL PRODUCTS DIVISION
ASSEMBLY INSTRUCTIONS
You do not need any special knowledge or experience to set up a EFX544,
however you will need assistance. Because of its weight and size, ask for several
assistants to help you assemble the EFX544.
To assist you in the assembly of the EFX544, the items in the hardware kit,
shown in Diagram 1, correspond to a particular letter in the alphabet. These
letters appear throughout the assembly instructions. Refer to Diagram 1, while
performing the following steps:
1. Unpack the EFX544 by removing the packing materials and loose contents
(electronic console, hardware kit, front cover, handrails, power cord, and
ribbon cable) from around the base frame assembly.
2. Remove the staples along the base of the box where the cardboard is
attached to the shipping pallet so that you can lift the box off of the pallet and
over the base frame assembly. Ask for assistance to move the EFX544 off
the shipping pallet. You will need to cut the tie wraps that hold the base
frame, stair arms, and handrails to the pallet.
CAUTION: To avoid injury and ensure your safety, you need assistants
to move the EFX544 off of the pallet. Do not drop the unit.
3. Make sure that the EFX544 is unplugged and turned OFF. Do not assemble
the EFX544 if it is plugged into a power outlet.
CAUTION: The assembled unit will not fit through a standard doorway.
Before installing the handrails, make sure that the EFX544 is located
where you plan to use it.
4. Take the following steps to secure the upper column support to the base
frame assembly:
a. Locate the screws (A) and washers (B) in the hardware kit. Place a
washer on each bolt and set them within easy reach.
Setting Up the C964 Treadmill Ergometer
To Next Page
Loading...
Need help?
General
