page 20
COMMERCIAL PRODUCTS DIVISION
QUICK START: If you wish to use the manual program, you can bypass the
setup prompts by pressing the QUICK START key. When you begin working out,
the amount of time you have been on the EFX544, the strides per minute, and
total caloric burn appear on the electronic console display. To display other
features, press the CHANGE key.
Note: If you press QUICK START while the start-up prompt is scrolling across
the display, the weight setting defaults to 150 pounds (70 kg) so all calorie
calculations and their associated displays are based on a body weight of 150
pounds. The time selection defaults to the club limit set in memory. However, you
can enter a weight or time setting, prior to pressing QUICK START.
CHANGE: Each time you press the CHANGE key, the indicator lights appear
next to a set of features that are displayed. For example, if the TIME indicator is
lit, you can “change” the display to show the TOTAL STRIDES that you have
taken since you started your workout. The SEGMENT TIME and CALories PER
MINUTE also appear.
GRAPHIC DISPLAY ON THE EFX544
The graphic display window on the EFX544 electronic console provides informa-
tion about your workout session. The displays prompt you to enter specific
information before a workout. Small lights next to the words indicate the type of
information that is needed. During your workout, the left window displays the
course profile and Smart Rate. As you proceed through your workout, your
position is indicated by a blinking cell.
Error messages can also appear on the display. These messages explain
problems that may arise while you are using the EFX544. Some problems you
can solve while other problems require a qualified service technician. Refer to
Correcting Inconsistent Heart Rate Readings
. If you are unsure about an error
message, please call a Precor authorized service center.
WEIGHT: Change the weight displayed by using any or key. Accept the
weight being displayed by pressing ENTER. The indicator light moves onto the
TIME prompt.
TIME: Change the time displayed by using any or key. The workout time can
be limited—see
Club Customization Program
. If a club limit does exist, you can
change the workout time up to the limit allowed. Accept the time being displayed
by pressing ENTER. The indicator light moves onto the COURSE prompt.
AGE: An age prompt appears only if the optional Precor heart rate receiver is
properly installed in the electronic console. Any and key enables you to
decrease or increase the numerical display. Once the correct number appears,
press ENTER. Make sure that you enter your correct age since it is used to
determine your proper Smart Rate target zone.
To Next Page
Loading...
