page 19
COMMERCIAL PRODUCTS DIVISION
are smooth on one side and slightly protrude on the other side. Place the
protrusions against the handlebar brackets.
c. Align the holes and insert the three bolts (E) and washers (F). Thread the
bolts (E) into the holes using your fingers.
d. Tighten the bolts securely using a 1/2-inch socket wrench.
e. Repeat steps a. through d. to secure the opposite handlebar.
20. Attach the handlebars to the pivot arm. Diagram 14. Proceed with one
handlebar at a time. When you have completed the installation steps for one,
perform the same steps for the opposite handlebar.
Diagram 15
Secure the
bracket cover.
Bracket cover
Upright support
bracket
Remove screws from
beneath the upright
support bracket.
a. Remove the shoulder bolt (C) from the Hardware kit.
b. For ease of installation, slide the foot pedal to the top of the ramp.
c. On the same side, align the mounting holes on the handlebar and the
pivot arm.
d. Insert the shoulder bolt. Secure the handlebar to the lower pivot arm using
the hex key provided. Tighten the bolt securely. See Diagram 14.
21. Attach the bracket cover. Diagram 15. Take the following steps to attach the
cover over the upright support bracket.
CAUTION: Do not overtighten the screws or you may inadvertently cause
stress cracks in the plastic.
a. Move the handlebars out of the way.
To Next Page
Loading...
