36 Operating and Maintaining the P30 Console
Treadmill Auto Stop™ (Automatic Stop)
Function
Important: The default setting for this feature is ON. An
administrator can turn off this feature in the System Settings;
however, Precor recommends it remain ON.
The Auto Stop™ (Automatic Stop) feature is designed to
bring the treadmill to a gradual stop when it is not in use. This
might occur if a user steps off the treadmill before the end of
a workout and leaves the treadmill running.
Sixty seconds after a treadmill workout starts or resumes, the
equipment begins Auto Stop monitoring. If a user is detected,
then no message appears, and the selected workout
continues.
If no user is detected after an additional 30 seconds, the
console displays the message NO USER DETECTED,
STOPPING IN 10 SECONDS as notification of the pending
stop. During the display of this message, a ten second
countdown begins. If a user does not override the countdown,
the belt comes to a gradual stop after the countdown is
complete.
Note: Users weighing more than 90 pounds (41 kg) are
detected within the speed and position limits of the feature.
Users weighing 50 pounds (22.7 kg) to 89 pounds (40.5 kg)
may not be detected depending on their speed and location.
Always be aware of and follow the console’s instructions for
proper operation.
To Next Page
Loading...
Need help?
General
