Installing External Receivers 9
Creating the Channel List
While one of the receivers is connected and operating, create
a list of the channels that should eventually be available in the
channel guide on the P80 consoles. For each channel, note
the digit sequence that you must enter through the remote
control to select the channel directly (without using the
"channel up" and "channel down" buttons).
Tip: In many cases, the channel listing furnished by the
facility's TV service provider contains the digit sequence
information you will need.
If you are using I-O DATA receivers, choose the twelve
channels that the facility’s owner wants to offer. Program
these channels into the quick selection list, while making note
of which channel is assigned to which quick selection key.
Important: When configuring or moving a DirecTV receiver, do
not press its Resolution key.
To Next Page
Loading...
