22 Installing the P80 Console Media Adapter
Troubleshooting
If you encounter problems with the Media Adapter, please
check the common solutions in the following table before
contacting Precor Customer Support or your Precor dealer.
Problem Possible Solutions
No picture or sound is
played on one or more
channels.
• Verify that all cables are in place
and fully connected.
• Verify that the dialing sequences
set in the channel guide are
correct.
• If you are using I-O DATA
receivers, check that the quick
selection list on the receiver has
been set up correctly.
• Check that the receiver is still set
to 720p. If not, use a remote
control to reconfigure the
receiver.
The cable channels (or the
HDMI channels) on the
channel guide are not
displayed correctly.
• The P80 console cannot receive
both HDMI channels and cable
channels at the same time.
After the user changes the
channel, the text messages
describing the new channel
remain on the screen for
seven seconds or more.
• If you are using I-O DATA
receivers, check that the quick
selection list on the receiver has
been set up correctly and that the
channel guide on the P80 console
is using it.
• Some receiver manufacturers
design this behavior into their
software, and there is no way to
deactivate it.
To Next Page
Loading...
