Installing External Receivers 13
Connecting Receivers
The IR transmitter is fitted with an adhesive foam gasket.
When attached to a receiver, this gasket keeps the
transmitter positioned correctly and seals out any room light
that filters in to the junction box.
Important: The foam gasket is lined with an extremely strong,
permanent adhesive. Do not remove the liner from the gasket until
you are ready to install the IR transmitter.
To connect a receiver:
1. If necessary, attach the power supply cable to the power
connector on the receiver.
2. Attach one end of the HDMI cable to the HDMI extender
cable leading out of the piece of fitness equipment on
which you are currently working.
3. Attach the other end of the HDMI cable to the HDMI jack
on the receiver.
4. Locate the IR port on the receiver. This port is usually a
small, transparent opening in the front panel of the
receiver, but it may be designed to be difficult to see.
Important: If you are not sure about where the IR port is,
refer to the documentation for the receiver or contact the
receiver's manufacturer.
To Next Page
Loading...
Need help?
General
