Assembling the Treadmill 21
Hardware Kit (not to scale)
The hardware kit shipped with this equipment contains the
fasteners and other hardware components shown in the
following table. Before you begin assembly, make sure that
your hardware kit is complete. If not, please contact Precor
Customer Support.
Fasteners
Quantity
³₈-inch × 1-inch buttonhead
screws
12
¹₄-inch × 1-inch buttonhead
screws
4
¹₄-inch × ³₄-inch panhead
self-tapping screws
6
¹₄-inch × 1¹₂-inch panhead
self-tapping screws
2
³₈-inch narrow flat washers 12
¹₄-inch × ³₈-inch shoulder bolt 4
Square plastic grommet 2
Corner cover (2)
Access cover (2)
Note: Retrieve the cables and other hardware shipped with
the console before you begin installation.
To Next Page
Loading...
