64 Assembling and Maintaining TRM 800-Series Treadmills
Adjusting the Running Belt
If you are unsure about adjusting the running belt, call Precor
Customer Support (refer to Obtaining Service).
CAUTION: Take special care when aligning the running belt. Turn
OFF the treadmill while adjusting or working near the rear roller.
Do NOT wear loose clothing or allow your hair to hang loose
during this procedure. Do NOT adjust the running belt when
someone is standing on it. Be very careful to keep your fingers and
any other object clear of the belt and rollers, especially in front of
the roller and behind the deck. The treadmill will not stop
immediately if an object becomes caught in the belt or rollers.
Important: Make all belt adjustments on the adjusting bolts at
the rear corners of the treadmill, using the hex key provided, and
do not turn either bolt more than ¼ turn before checking the
alignment of the running belt again. Overtightening the adjusting
bolts can damage the treadmill.
To Next Page
Loading...
Need help?
General