Premier WP-4V - Semi-Annual Filter Maintenance

Page 12
VOC BLOCK
√ Stage 1 - Sediment Filter (part #: 104017)
√ Stage 2 - Carbon Block Filter (part #: 101009-White End Caps)
Clean lter housings (bowls) with a mild soap solution and rinse with
water. Check O-rings and lubricate with water soluble lubricant. KY
Jelly® or other water based lubricants may be used. Petroleum based
lubricants (such as Vaseline®) must not be used.
For more leverage you may leave the RO module attached to wall of
cabinet. If you are unable to access the module while it hangs, remove
it prior to changing lters. Starting with the closest housing
(Stage 1), remove it by turning it clockwise, empty water, then discard
lter. Continue on to the 2
nd
housing (Stage 2).
Insert the new sediment lter (cloth like appearance) into the 1st lter
housing which is the one closest to the side with tubing connections
and re-install housing.
6 Month System Maintenance
Turn off the incoming water supply to the RO by turning the needle
valve on the adapt-a-valve clockwise until it stops. (Follow the green
tube away from the RO system to nd the adapt-a-valve.)
Step 1
Step 3
Step 4
Step 5
Step 6
Let system sit for a few minutes after tank is empty to depressurize
before attempting to remove lter housings.
Open the RO Faucet and allow water to drain from the tank until it is
completely empty.
Insert the new Carbon Block lter (White End Caps) into the middle
housing and re-install housing.
Step 7
Step 2
Step 8
*Order lters by calling 1-800-752-5582 or buy online at www.premierH2o.com.
Turn water on to the unit by turning the needle valve on the adapt-a-
valve counter clock wise.
Note:
Water Can be saved in a container for drinking or to rinse system
parts.
Before re-installing the lter bowls back on to the system ,
check O-rings to make sure they are still in place.
Caution:
Open the RO faucet and leave it open until water begins to trickle out
(it will come out slowly).
Step 10
Step 9
Close the RO faucet allowing the storage tank to ll with water. It
may take 4 to 6 hours to ll the tank completely depending on the
production capability of the membrane, local water temperature and
water pressure.
** To reset the electronic monitor during replacement of lters, simply slide out the battery
from the base of the faucet and reinsert.
Note: