13
BASIC SETUP SEQUENCE
1/ Enable/Disable SERIES 2 COMPATIBILITY (Currently
disabled). [Memory 99, page 18]
2/ Select ELC RELAY TYPE (Currently N.O.).
[Memory 82, page 15]
3/ Select EGRESS switch type (Currently N.O. level
triggered). [Memory 81, page 14]
4/ Set ELC OPERATE TIME (Currently 10 seconds).
[Memory 83, page 15]
5/ Enable/Disable DOOR INPUT (Currently disabled).
[Memory 84, page 15]
6/ Set Door Open Too Long time (Currently 60 seconds).
[Memory 85, page 16]
7/ Enable/Disable DOOR FORCED OPEN DETECTION
(Currently enabled). [Memory 86, page 16]
8/ Enable/Disable AUTOMATIC RELOCK (Currently
enabled). [Memory 80, page 14]
9/ Enable/Disable 1 MINUTE LOCKOUT (Currently
disabled). [Memory 87, page 16]
10/ Enable/Disable HIGH SECURITY MODE (Currently
disabled). [Memory 88, page 17]
11/ Set HIGH SECURITY MODE TIMING, if enabled in
step 9 above (Currently 60 seconds).
[Memory 89, page 17]
12/ Enable/Disable MOMENTARY CODES TURN OFF
TOGGLE (Currently disabled). [Memory 91, page 18]
To Next Page
