PRESCO PAC1 - Installation Programming Summary

19
INSTALLATION PROGRAMMING SUMMARY
Enable/Disable Automatic Relock. (default = enabled)
   x . x =  for disabled, x =  for enabled.
Select EGRESS switch type. (default = N.O.)
   x . x =  for N.O. level, x =  for N.C.
level,
x =  for N.O. edge, x =  for N.C. edge.
Select ELC relay type. (default = N.O.)
   x . x =  for N.O. (fail secure),
x =  for N.C. (fail safe).
Set ELC operating time. (default = 10 seconds)
   xxx . xxx = 1 to 255 (seconds).
Enable/Disable DOOR input. (default = disabled)
   x . x =  for disabled, x =  for enabled.
Set DOTL timer. (default = 60 seconds)
   xxxx . xxxx = 0 to 9999 (seconds).
Enable/Disable Door Forced detection. (default = enabled)
   x . x =  for disabled, x =  for enabled.
Enable/Disable 1 minute lockout. (default = disabled)
   x . x =  for disabled, x =  for enabled.
Select High Security Mode. (default = Normal Mode)
   x . x =  for Normal Mode,
x =  for Any Two User Codes,
x =  for Code 000 or 001 and any other,
x =  for Sequentially Stored User Codes.