PRESCO PAC1 - One Minute Lockout; High Security Mode

6
One Minute Lockout
To increase security the PAC1 can be set to lock out all codes
for a period of 1 minute after 5 incorrect codes have been
tried (set in memory 87, refer to page 16). Note that this
feature should not be enabled if access must be guaranteed
in an emergency situation.
High Security Mode
The PAC1 can be set up to operate in one of the four modes
described below.
Normal Mode (High Security Mode Disable)
Any one of the programmed user codes will operate the
ELC relay.
Any Two User Codes
Any two of the programmed user codes must be used
together to operate the ELC relay.
Code 000 or 001 and any other user code
The user code stored in memory 000 or 001 used together
with any other valid user code will operate the ELC relay.
Sequential Memory User Codes
Two user codes in sequential memory locations must be
used together to operate the ELC relay. The paired code
locations start with an even number, e.g. 000 & 001, 056
& 057, 138 & 139, etc.
IMPORTANT NOTE: When the PAC1 is set up to use any
of the high security modes above, the ELC relay will only
operate in Momentary (timed) Mode even if the codes are
programmed as Toggle codes.